Adlink Express-BASE Manual de usuario descargar pdf (Pagina 35)

Page 35Express-BASE User’s Manual

6.20 Other Jumper Settings

JP1: LPC Port 80

Free Run: BIOS will complete the boot process

Single Step: BIOS will execute step-by-step by

pressing SW2 button

Jumper Status

1-2 Free Run <<<<

2-3 Single Step

JP2/JPZ5: BIOS Selection

See 7 Secondary BIOS on page 37 for

a detailed description.

JPZ5 JP2 Status

1-2 1-2 Module BIOS <<<<

1-2 2-3 Carrier FWH BIOS

2-3 1-2 Carrier SPI BIOS

2-3 2-3 Reserved

NOTE: <<<< indicates default setting

JP5: CMOS Clear

To clear CMOS, shut down the power and short

pins 2 and 3 (shorts VBAT to ground).

Jumper Status

1-2 Normal <<<<

2-3 Clear CMOS

JPY6: TPM Signal Jumper

Configuring the jumper to "ON" pulls the

TPM signal high and "OFF" does nothing

to the TPM signal. Dependent upon module's

design for the TPM signal.

Jumper Status

1-2 ON

2-3 OFF <<<<

JP6: External PEG/Internal Graphics with SDVO Selection

This jumper controls PCIE7: PCI Express x16 mode and SDVO mode. Enables/disables internal

graphics or external graphics on the x16 PCI Express Graphics (PEG) port. If the PEG port is

enabled, both the internal graphics and SDVO will be disabled.

Jumper Enable

1-2 Internal Graphics with SDVO <<<<

2-3 PCI Express x16 slot graphics

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 45 46

Sin comentarios

Adlink Express-BASE Manual de usuario Pagina 35