Adlink CoreModule 430 Manual de usuario descargar pdf (Pagina 37)

Chapter 3 Hardware

CoreModule 430 Reference Manual 31

Power Interface

The CoreModule 430 requires one +5 volt DC power source. If the +5VDC power drops below ~4.65V, a

low voltage reset is triggered, resetting the system.

The power input header (J7) supplies the following voltages and ground directly to the module:

• 5.0VDC +/- 5% @ 1.35 Amps

Table 3-16 describes the pin signals of the Power interface, which uses a 10-pin, right-angle header with 2

rows, odd/even sequence (1, 2), and 0.100" (2.54mm) pitch.

Note: The shaded table cells denote power or ground.

Table 3-16. Power Interface Pin/Signals (J7)

Pin Signal Descriptions

GND Ground

+5V +5 Volts

Key/GND Key Pin on connector/Grounded on board

+12V +12 volts routed to PC/104

GND Ground

6 NC Not connected

GND Ground

+5V +5 Volts

GND Ground

+5V +5 Volts

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 55 56

Sin comentarios

Adlink CoreModule 430 Manual de usuario Pagina 37