Adlink CoreModule 430 Manual de usuario descargar pdf (Pagina 28)

Chapter 3 Hardware

22 Reference Manual CoreModule 430

Note: The shaded table cell denotes ground. The * symbol indicates the signal is Active Low.

Table 3-6. Serial Ports 1 & 2 Interface Pin/Signal Descriptions (J3, J9)

Pin # Signal DB9 # Description

1 DCD* 1 Data Carrier Detect – Indicates external serial device is detecting a

carrier signal (i.e., a communication channel is currently open). In direct

connect environments, this input is driven by DTR as part of the DTR/

DSR handshake.

2 DSR* 6 Data Set Ready – Indicates external serial device is powered, initialized,

and ready. Used as hardware handshake with DTR for overall readiness.

3RXD

Rx Data –

2 Receive Data – Serial port receive data input is typically held at a logic 1

(mark) when no data is being transmitted, and is held “Off” for a brief

interval after an “On” to “Off” transition on the RTS line to allow the

transmission to complete.

Serial Port 1 or 2 – If in RS-485 mode, this pin is Rx Data Negative.

4RTS*

Tx Data +

7 Request To Send – Indicates serial port is ready to transmit data. Used as

hardware handshake with CTS for low level flow control.

Serial Port 1 or 2 – If in RS-485 mode, this pin is Tx Data Positive.

5TXD

Tx Data –

3 Transmit Data – Serial port transmit data output is typically held to a

logic 1 when no data is being sent. Typically, a logic 0 (On) must be

present on RTS, CTS, DSR, and DTR before data can be transmitted on

this line.

Serial Port 1 or 2 – If in RS-485 mode, this pin is Tx Data Negative.

6CTS*

Rx Data +

8 Clear To Send – Indicates external serial device is ready to receive data.

Used as hardware handshake with RTS for low level flow control.

Serial Port 1 or 2 – If in RS-485 mode, this pin is Rx Data Positive.

7 DTR* 4 Data Terminal Ready – Indicates serial port is powered, initialized, and

ready. Used as hardware handshake with DSR for overall readiness.

8 RI* 9 Ring Indicator – Indicates external serial device is detecting a ring

condition. Used by software to initiate operations to answer and open the

communications channel.

GND 5 Ground

10 Key/NC NC Key Pin/Not connected

Table 3-7. Serial Ports 3 & 4 Interface Pin/Signal Descriptions (J13, J14)

Pin # Signal DB9 # Description

1 DCD* 1 Data Carrier Detect – Indicates external serial device is detecting a

carrier signal (i.e., a communication channel is currently open). In direct

connect environments, this input is driven by DTR as part of the DTR/

DSR handshake.

2 DSR* 6 Data Set Ready – Indicates external serial device is powered, initialized,

and ready. Used as hardware handshake with DTR for overall readiness.

3 RXD 2 Receive Data – Serial port receive data input is typically held at a logic 1

(mark) when no data is being transmitted, and is held “Off” for a brief

interval after an “On” to “Off” transition on the RTS line to allow the

transmission to complete.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 55 56

Comentarios a estos manuales

Sin comentarios

Adlink CoreModule 430 Manual de usuario Pagina 28

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Adlink CoreModule 430